Garmin Edge 500 Cycling Computer Bundle with HR-Cadence Review

Tags: , , , , , , , , , , ,
Previous Post

Louis Garneau Multi RX Cycling Shoe – Men’s Appraisal

Next Post

Surly Cross Check 46cm Frameset Foamy Hospital Green Study

Comments

  1. Reply

    Power Cycling Electronics? I know it fixes most problem I have with electronics but why does it work?

    Thanks for your help

    View Comment
    1. Reply

      The electronic components have many circuits inside, and when one or more change voltage levels when they aren’t supposed to, then it doesn’t work properly and you get “hung up”.

      When you turn off the power, all of the electricity in the circuits bleeds away to zero, so that when you turn it on again, all the circuits are starting off fresh.

      You should wait a few seconds between turning your electronics off and turning them back on to allow the voltages to bleed off completely.

      View Comment
  2. Reply

    Power Cycling Electronics? I know it fixes most problem I have with electronics but why does it work?

    Thanks for your help

    View Comment
    1. Reply

      The main reasons why power cycling is done is to have an electronic device reinitialize its configuration or recover from an unresponsive state, such as “Crash” or “Hanging”.

      Most modern electronic devices have a program ROM chip or BIOS, with their proprietary programming. Over the course of normal operation, certain unforeseen events such as power surge and electrical noise can cause electronic devices to malfunction, and the simplest way to reinitialize the program is to cycle the device’s power.

      I hope my answer explains your question.

      View Comment
  3. Reply

    Power Cycling Electronics? I know it fixes most problem I have with electronics but why does it work?

    Thanks for your help

    View Comment
    1. Reply

      This forum is about bicycles and riding them: cycling get it?

      View Comment
  4. Reply

    Electronics – Computers? A memory chip is labeled as 2114-20. What does the 20 indicate?

    View Comment
    1. Reply

      TRC read cycle time is 200 clock cycles minimum

      max access time = 200 nSec

      http://www.physics.ucdavis.edu/Classes/Physics116/Lab16_02all_rev.pdf

      if you notice the other chips 2114-3 are tRC 300 and max access time of 300=nSec

      So I am going to say that the 20 designates the access time of the memory chip.

      =)

      View Comment

Leave a Reply to Sarah Cancel reply